Two stage Sliding / Modulating Heavy Oil Burner

★ Air atomization.

★ By adjusting the combustion air and combustion head, the best combustion parameters can be obtained.

★ Hinge joint, open at both sides, easy for maintenance.

★ Progressive/proportional servo motor is used for the first and second stage air flow regulation.

★ The electronic proportional type uses two servo motors to control the proportional regulation of fuel and air respectively.

★ When the burner is suspended, the damper is closed to reduce the heat loss in the furnace.

★ Servo motor with CAM can regulate the supply of air and fuel at the same time.

★ A flange and high temperature insulation pad are used to connect and fix the boiler.

★ The burner air inlet is designed with noise reduction.

★ High temperature resistant stainless steel burner flame tray.

★ Independent heavy oil electric heater group and three-phase motor drive oil pump.

★ Light resistance detects flame.

★ Electrical plant protection rating Ip40.

Electronic Heavy Oil Burner

★ Air or steam atomization.

★ Ability to obtain optimal combustion values by regulating combustion air and blast-pipe.

★ Hinge joint, open at both sides.

★ Maintenance facilitated by the fact that the atomisation unit can be removed without having to remove the burner from the boiler.

★ The burner is paused, close the throttle to reduce the loss of furnace heat.

★ The electronic modulation type uses two servo motors to control the proportional regulation of fuel and air respectively.

★ It is equipped with regulator and stop valve.

★ With the fuel pre-heater which installed with thermometer and adjustable temperature controller.

★ One flange and one insulating seal for boiler fastening.

★ Combustion air intake with air flow adjustment device.

★ Adiustable burner head with steel gaspipe abd diffuser.

★ Three-phase electric motor to run fan.

★ Photocell detects the flame.

★ Electrical plant protection rating IP40.

Electronic Heavy Oil Burner

★ Air or steam atomization.

★ Ability to obtain optimal combustion values by regulating combustion air and blast-pipe.

★ Hinge joint, open at both sides.

★ Maintenance facilitated by the fact that the atomisation unit can be removed without having to remove the burner from the boiler.

★ The burner is paused, close the throttle to reduce the loss of furnace heat.

★ The electronic modulation type uses two servo motors to control the proportional regulation of fuel and air respectively.

★ It is equipped with regulator and stop valve.

★ With the fuel pre-heater which installed with thermometer and adjustable temperature controller.

★ One flange and one insulating seal for boiler fastening.

★ Combustion air intake with air flow adjustment device.

★ Adiustable burner head with steel gaspipe abd diffuser.

★ Three-phase electric motor to run fan.

★ Photocell detects the flame.

★ Electrical plant protection rating IP40.